This short Mosin Nagant scope mount for your M44, M39, or 91/30 rifle requires NO DRILLING for installation. This Mosin Nagant M38, M44, and T53 scout scope short mount will allow you to use a long-eye relief scout scope in a shorter position compared to a full length Mosin Nagant Scout scope mount. The scope mount is centered forward of the Mosin Nagant bolt handle, so there is no need to change the bolt handle on your rifle to a bent bolt. This scope mount It converts your Mosin Nagant into a scout sniper rifle quickly and easily. The mount attaches to the rear sight of models 91/30, M44, M38, M39, and Chinese T53 rifles. The scope mount is made from black anodized aircraft grade aluminum. It accepts all standard Weaver-Picatinny 1913 accessories. Limited Lifetime Warranty.
Black anodized aircraft grade aluminum
Base Mount Weaver / Picatinny
No drilling, tapping, or gun smithing required
Length: 4 inches
Width: 0.75 inches
Height" 0.72 inches
Limited Lifetime Warranty
Easy Installation Punch out rear sight cross pin then remove rear sight leaf and spring. Place Mosin Nagant Rifle scope mount between sight ears and tighten side screws. Loosen the three set screws on top of the mount to adjust elevation. The mount should be parallel with the barrel. Installing this scope mount is very simple and requires only a few hand tools. Once properly installed on your rifle, this scope mount is a solid mounting platform for your scope.