UTG PRO 30mm-2PCs Low Profile P.O.I Picatinny Rings
This Leapers RWU013010 UTG PRO® 30mm 2PCs Low Profile P.O.I Picatinny Rings Are 50 caliber BMG Rated and made in the USA. Scope rings Are Designed to Fit on Mil-spec 1913 Picatinny Rail Platforms. Low Profile P.O.I® (Precision Optics Interface) Rings, Have a 25mm Center Height to Fit Optics with a 30mm Tube, and up to a 49mm Outer Objective. The Innovative P.O.I® (Precision Optics Interface) Addresses 3 of the Most Critical Areas in Scope Rings. Progressively Machined for a Precise Inner Ring Surface to Achieve a Seamless Ring-to-Scope Interaction. Low Profile and Flush-fitting Locking Side Plate Controlled by Dual Spring Loaded Guide Rods Interfacing with the Rail with Torx Screw Locking to Ensure Secure and Repeatable Zero Hold. Square-shaped Integral Recoil Stop Interfacing with a Picatinny Slot via Complete Surface Contact to Eliminate the Possibility of Forward and Aft Movement from Recoil Vibrations. 2 Piece Ring Set, Each Equipped with 4 Top Torx Screws Designed with a 22mm Ring Width. Designed to Fit on Mil-spec 1913 Picatinny Rail Platforms. Machined from 6061-T6 Aluminum Alloy and 4605 Steel with Matte Black Hard Coat Anodized. UTG PRO® Original Snag-free Contoured Profile with Reduced Weight and Size. UTG Limited lifetime warranty.
NOTE: We recommended to tighten the ring top screws with a torque value of about 25 inch-lb and the side plate screw with torque value of about 45 inch-lb.
